![]() Remove the lower shock absorber mounting bolt. IRS ONLY - Remove the drive shaft at the outer end (six small bolts - you need an 8mm 1. Note: Adjustable spring plates have an adjusting bolt and an additional short plate at the torsion bar end of the spring plate - front of car end). Check to see if your car has had adjustable spring plates (after- market item) fitted. The IRS models also have a dog- leg shaped diagonal arm which is bolted to the brake hub assembly and rotates on a fitting on the torsion bar tube. Note: The swing axle cars have only one spring plate. Examine the spring plate ends where they meet the fitting on the axle end. IRS ONLY - remove the brake drums, brake internals, and brake backing plate. Raise the whole car off the ground - measurements are easier with the car level, and you need some working room under the rear. VW rear suspensions sometimes sag as the car ages, especially if it has carried a few large loads.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |